![]() You can leave the wires attached and simply lay the console across the top of the washer out of the way. Use care not to pull or damage any of the wiring. If you push in slightly while pulling outwards the panel pops off. Take a putty knife and insert it under the console seam right above the door. ![]() ![]() Remove the operator console by removing the dispenser and the scew(s) behind it. The panel should slide back, and then lift off. Remove the washer top panel by removing the three torx-type screws (or 7mm) where it attaches in the rear of the washer. A replacement bellow isn't cheap (prices vary, but are around $75-80), so hopefully these helpful steps will eliminate the need to call a repair service and pay the additional labor charges.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |